Name:. PES board / stick aka: sulfone Julong. Excellent polyether sulfone resin (PES) board / stick a comprehensive performance thermoplastic polymer materials, is one of the special engineering plastics currently applied the few. PES board / stick it has excellent heat resistance, mechanical properties, insulation properties, especially those with continuous use, and rapid temperature changes in the environment can maintain stable performance under high temperature and other advantages in many areas has been widely used heat-resistant thermal deformation temperature of 200 ~ 220 ℃, continuous use temperature of 180 ~ 200 ℃, UL temperature index of 180 ℃. Hydrolysis resistance can be resistant to 150 ~ 160 ℃ hot water or steam, at a high temperature from acid, alkali erosion. Modulus temperature consul substrate modulus at -100 ℃ to 200 ℃ almost constant, especially at above 100 ℃ any kind of thermoplastic resin are good. Creep resistance at 180 ℃ temperature range below the creep resistance of thermoplastic resin is one of the most outstanding, especially glass fiber reinforced PES resin is better than some of thermosetting resins. Dimensional stability, low coefficient of linear expansion, and its temperature is also little trust of its characteristics. Characterized by a 30% glass fiber reinforced PES resin, its linear expansion coefficient of only 2.3 × 10 / ℃, and 200 ℃ until it can still maintain the aluminum approximating value. The impact resistance of a polycarbonate having the same impact resistance. Not reinforced resin can be riveting, but the shrill notch sensitive, so the design should pay attention to. Non-toxic health standards are recognized by the US FDA, also in line with the requirements of Notice No. 178 and No. 434 Japanese Ministry of Health. Self-extinguishing flame resistance, do not add any that has excellent flame retardant properties, up to UL94V-0 grade (0.46mm) PES chemical resistance resistance to gasoline, oil, lubricants and other oil and Freon other cleaning agents, it is an amorphous resin solvent cracking best. However, it is resistant to bad performance, polar solvents such as chloroform, use should be noted. Pros: from -100 to + 200 ℃ range have high mechanical and tensile strength, good dielectric properties, rigidity hard, remain high impact strength at low temperatures. Very good hydrolysis resistance and dimensional stability, self-extinguishing, low smoke sex, USP recognition. Can repeat pasteurized and high resistance to aging and anti-radiation, high temperature resistant, flame retardant. Specifications: Material: thickness (6 to 100 mm) * width * length 1000 mm 610㎜ bar: ￠ 6 ~ ￠ 200mm * 1000mm Color: deep yellow translucent, black, taupe